Typical office and retail jobs
- Flushometer valves rebuilt on toilets and urinals
- Sensor faucets and manual taps repaired or replaced
- Washroom and staff kitchen drains cleared
- Small electric water heaters for coffee stations and sinks
- Leaks traced above drop ceilings and behind panels
- Mop sinks and floor drains reset and sealed
What we bring
- ABS, copper and PEX fittings
- Pipe cutters, torch and press tools
- Drop sheets and a wet vacuum
Tested before we leave
- Every new joint checked under pressure
- Drains run at full flow
- Work area cleaned before we leave
Signs to call before it gets worse
- A urinal or toilet runs on after every flush
- Water stains on ceiling tiles
- Sewer smell from a rarely used floor drain
- No hot water at the staff sink
- A slow drain in a shared washroom
How we keep the business running
- We agree the access time with you or the landlord.
- Only the affected fixture or branch is isolated where possible.
- Work areas are kept tidy and out of customer view.
- Each repair is tested before the water is turned back on fully.
- You get a short summary for the landlord or head office.
New tenants and fit-outs
When a unit changes use, the plumbing often has to change with it. We can look at the existing rough-ins, explain what a new washroom or sink needs, and work with your contractor. Permit requirements depend on the scope, so check them before work starts.
Useful to have ready
- Location of the unit shut-off and water heater
- Landlord or property manager contact
- Any previous plumbing reports for the unit